Ks0122 keyestudio EASY plug PIR Motion Sensor

From Keyestudio Wiki
Jump to navigation Jump to search
EASY plug Flame Sensor Module

Introduction

PIR stands for Pyroelectric Infrared (many times, they are also referred as Passive Infrared sensors). This is because their principle of operation is based on the detection of infrared energy emitted by a moving body.
The PIR sensor can detect infrared signals from a moving person or moving animal, outputting switching signals.

One important thing to mention is that when motion is detected, the output will stay high for 2.3 to 3 seconds after the motion stops.
Regarding the power supply, it can work with voltages of both 3.3V and 5V. The device has a detection range of 7 meters and a detection angle of 100º.
This module should be used together with EASY plug control board.

Special Note:
The sensor/module is equipped with the RJ11 6P6C interface, compatible with our keyestudio EASY plug Control Board with RJ11 6P6C interface.
If you have the control board of other brands, it is also equipped with the RJ11 6P6C interface but has different internal line sequence, can’t be used compatibly with our sensor/module.


Specification

  • Connector: Easy plug
  • Input Voltage: 3.3 ~ 5V, Maximum 6V
  • Working Current: 15uA
  • Working Temperature: -20 ~ 85℃
  • Output Voltage: High 3V, Low 0V
  • Output Delay Time (High Level): about 2.3 to 3 Seconds
  • Detection angle: 100°
  • Detection distance: 7 meters
  • Output Indicator LED (When output HIGH, it will be ON)
  • Pin limit current: 100mA


Technical Details

  • Dimensions: 38mm*20mm*18mm
  • Weight: 5.6g


Connect It Up

Connect the EASY Plug PIR Motion sensor and LED module to control board using RJ11 cables. Then connect the control board to your PC with a USB cable.
thumb


Test Code

Below is an example code. Open or drag below code to Mixly Blocks and upload.

thumb


What You Should See

After uploading the code, slide the potentiometer, the servo motor will rotate to a certain angle.
thumb

Done uploading the code, if the sensor detects someone moving nearby, you should see the LED is turned on.
thumb
Open the serial monitor and set the baud rate to 9600, it will print out the data.
thumb


Controlling Fan Motor

Hookup Guide

thumb


Test Code

thumb


What You Should See
If the sensor detects someone moving nearby, you should see the LED is turned on, and the fan motor is rotating. Otherwise, LED is turned off and motor stops rotating.
thumb

thumb



Resources

https://fs.keyestudio.com/KS0122


Buy from