Ks0204 keyestudio GUVA-S12SD 3528 Ultraviolet Sensor

From Keyestudio Wiki
Jump to: navigation, search

Introduction

keyestudio GUVA-S12SD 3528 Ultraviolet Sensor is used to detect ultraviolet light. It includes GUVA-S12SD, applied to measure ultraviolet index of intelligent wearable device, such as watches,smart phone and outdoor device with UV index detecting. It still is used to monitor the intensity of ultraviolet light and as a UV flame detector when disinfecting things by ultraviolet light.


thumb

Parameters

  • Size:15mm×30mm×0.7mm
  • Supply Voltage:2.5V~5V
  • Output Signal:Analog Signal
  • Parameters of GUVA-S12SD
  • Detecting Range of Spectrum:240-370nm
  • Active Region:0.076mm2
  • Responsivity:0.14A/W
  • Dark Current::1nA
  • Light Current:101~125nA UVA Light,1mW/cm2

Connection Diagram


thumb

Sample Code

/*
  AnalogReadSerial
  Reads an analog input on pin 0, prints the result to the serial monitor.
  Attach the center pin of a potentiometer to pin A0, and the outside pins to +5V and ground.

 This example code is in the public domain.
 */

// the setup routine runs once when you press reset:
void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
}

// the loop routine runs over and over again forever:
void loop() {
  // read the input on analog pin 0:
  int sensorValue = analogRead(A0);
  // print out the value you read:
  Serial.println(sensorValue);
  delay(1);        // delay in between reads for stability
}

Result

After wires are connected, upload the program; when power on, open serial monitor displaying data showed as following picture.


thumb

Shine UV lamp to the sensor, and the data on serial monitor is changing showed as following picture.


thumb

Resources

PDF:

https://drive.google.com/open?id=1lRIuRpHX-y2Iy9ptPspzt2GgiMQ3GHn2

Buy from

Official Website

http://www.keyestudio.com/keyestudio-guva-s12sd-3528-ultraviolet-sensor.html