Ks0268 keyestudio SHT10 Digital Temperature Sensor

From Keyestudio Wiki
Jump to: navigation, search

Introduction

Keyestudio SHT10 digital temperature sensor is a temperature and humidity composite sensor containing digital signal outputs calibration. It uses patented micromachining technology (CMOSens®) in the process of industrial COMS, which ensure that the product has high reliability and excellent long-term stability. Sensor has full scale calibration and two digital interface, which can be directly connected with the microcontroller, with the features of high reliability, strong stability, rapid response, low power consumption, strong anti-interference and accurate dew point measurement and so on. And its products can be applied into various occasions.
thumb

Specification

  • Working Voltage:5V(DC)
  • Interface:4PIN port
  • Humidity Measurement Range:0---100%RH
  • Humidity Measurement Accuracy:±4.5%RH(20%---80%RH)
  • Humidity Measurement Resolution:0.03%RH
  • Temperature Measurement Range:-40---123.8℃
  • Temperature Measurement Accuracy:±0.5℃ error(in 25℃),±0.9℃ error(among 0---40℃)
  • Temperature Measurement Resolution:0.01℃
  • Weight:2.6g

Connection Diagram


thumb


Sample Code

/* Lab10 - SHT1x serials (SHT10, SHT11, SHT15) Reading sample of hygrothermograph
 * 
 * Need to install SHT1x Library:
 *    [url]https://github.com/practicalarduino/SHT1x/[/url]
 */
 
#include <SHT1x.h>
 
// define SHT1x connection pin
#define dataPin  11
#define clockPin 10
 
// Initialize sht1x object
SHT1x sht1x(dataPin, clockPin);
 
void setup()
{
   Serial.begin(9600);
}
 
void loop()
{
  // declare three variables, representing temperature (Celsius), temperature (Fahrenheit) and humidity
  float temp_c, temp_f, humidity;
 
  // read SHT1x temperature and humidity value
  temp_c = sht1x.readTemperatureC();
  temp_f = sht1x.readTemperatureF();
  humidity = sht1x.readHumidity();
 
  // Output the temperature and humidity value to Serial Port
  Serial.print("Temperature: ");
  Serial.print(temp_c, 1);  // Show one after the decimal point
  Serial.print("C / ");
  Serial.print(temp_f, 1);  // Show one after the decimal point
  Serial.print("F. Humidity: ");
  Serial.print(humidity);
  Serial.println("%");
 
  delay(1000);
}

Library Download of SHT1x: [1]


Result

Wiring as the above diagram and burning the code,after powered-on, open the serial monitor, it will display the current test temperature and humidity, as the graph shown below.


thumb

Resources

PDF:

https://drive.google.com/open?id=1HEjZ1ljbMFK37UhyXBaj5kXJ7tprrV9w

Library Download of SHT1x:

https://drive.google.com/open?id=1EU4eKo56RDp9W4sqj-001Ta7kE0oHuRj

Buy from

Official Website

http://www.keyestudio.com/keyestudio-sht10-digital-temperature-sensor.html