Ks0089 MKS BaseV1.2 3D Printer Controller Board (RAMPS 1.4 + Arduino 2560 Remix Board): Difference between revisions
Keyestudio (talk | contribs) (Created page with "==MKS BaseV1.2 3D Printer Controller Board (RAMPS 1.4 + Arduino 2560 remix board)== <br>500px|frameless|thumb<br> ==Intruduction== The new MKS Base 1.2 3D...") |
Keyestudio (talk | contribs) |
||
Line 28: | Line 28: | ||
<br>[[File:892.png|500px|frameless|thumb]]<br> | <br>[[File:892.png|500px|frameless|thumb]]<br> | ||
Download the codes here: http://183.134.24.55/7326097.s21d-7.faiusrd.com/0/ABUIABAAGAAgir2_twUo_NjbtwQ?f=ks0089+supporting+file+RAMPS+1.4.rar&v=1458544268&wsiphost=local Download supporting file] | Download the codes here: [http://183.134.24.55/7326097.s21d-7.faiusrd.com/0/ABUIABAAGAAgir2_twUo_NjbtwQ?f=ks0089+supporting+file+RAMPS+1.4.rar&v=1458544268&wsiphost=local Download supporting file] | ||
<br>[[File:893.png|500px|frameless|thumb]]<br> | <br>[[File:893.png|500px|frameless|thumb]]<br> | ||
[[Category: 3D Printer]] | [[Category: 3D Printer]] |
Revision as of 15:11, 24 September 2016
MKS BaseV1.2 3D Printer Controller Board (RAMPS 1.4 + Arduino 2560 remix board)
Intruduction
The new MKS Base 1.2 3D Printer Controller board combines and improves the assets of the RAMPS 1.4 and Arduino Mega 2560 boards on a fantastic single board solution. The MKS Base 1.2 is an optimal 3D printer controller solution for your Reprap 3D Printer.
Main features
The MKS Base 1.2 solves interface connection problems between the Arduino Mega 2560 and RAMPS 1.4 boards by having both integrated into a single board
5 Stepper Motor Driver Slots. The boards supports a wide variety of Stepper Motor Drivers - most notably A4988, DRV8825 and Ice-Blue Stepper Motor drivers drive
The MKS Base 1.2 board uses a high quality 4-layer PCB which optimizes heat dissipation
Firmware can use the same configuration as RAMPS 1.4
Easy DISPLAY + SD-CARD connector - compatible pin header on board for 12864 & 2004 LCD Display controller panels.
6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
3 x 5V output, 3 x Power voltage output
Reserve motor pulse and direction output port
Support 12V-24V power input
List
MKS BaseV1.2 3D Printer Controller Board
usb cable
Connection diagram
Download the codes here: Download supporting file