Ks0112 keyestudio EASY plug Digital Push Button: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
Line 9: Line 9:


<span style=color:red> '''Special Note:''' <br>
<span style=color:red> '''Special Note:''' <br>
The sensor/module is equiped with the RJ11 6P6C interface, compatible with our keyestudio EASY plug Control Board with RJ11 6P6C interface. <br> If you have the control board of other brands, it is also equiped with the RJ11 6P6C interface but have different internal line sequence, can not be used compatibly with our sensor/module. </span><br>
The sensor/module is equipped with the RJ11 6P6C interface, compatible with our keyestudio EASY plug Control Board with RJ11 6P6C interface. <br> If you have the control board of other brands, it is also equipped with the RJ11 6P6C interface but has different internal line sequence, can’t be used compatibly with our sensor/module. </span><br>


<br>
<br>

Revision as of 09:35, 22 May 2019

Keyestudio EASY plug Digital Push Button

Introduction

The EASY Plug Push-button module is a tidy little design that lets you control a DC power source using an everyday tactile button.
This basic application module is widely applied to Arduino, Raspberry Pi platforms.
When the button is pressed, it outputs HIGH level signal; if release the button, it outputs LOW level signal.
You can simply connect to an IO port to have your first taste of Arduino.
This sensor needs to be used together with EASY plug control board.

Special Note:
The sensor/module is equipped with the RJ11 6P6C interface, compatible with our keyestudio EASY plug Control Board with RJ11 6P6C interface.
If you have the control board of other brands, it is also equipped with the RJ11 6P6C interface but has different internal line sequence, can’t be used compatibly with our sensor/module.


Specification

  • Connector: Easy plug
  • Supply Voltage: 3.3V to 5V
  • Large button and high-quality top cap
  • Sensor type: Digital


Technical Details

  • Dimensions: 38mm*20mm*18mm
  • Weight: 5.6g


Connect It Up

Connect the EASY Plug push button sensor and LED module to control board using RJ11 cables.

thumb


Example 1: Button Controlled Light


Upload the Code
Below is an example code. Open or drag below code to Mixly Blocks and upload.

thumb


What You Should See
Powered up and upload well the code, press down the button, LED module is turned on. While release the button, LED is off.
thumb

thumb

Open the monitor, it will print out the value read from the button.
thumb



Example 2: Simulating Table Lamp


Upload the Code
Below is an example code. Open or drag below code to Mixly Blocks and upload.
thumb


What You Should See
Powered up and upload well the code, press down the button, LED light is turned on, it will not be off when release the button; But if press the button once again, LED will be turned off. It seems like your table lamp.

thumb

Open the monitor, you should be able to see how many times do you press the button.
thumb



Resources

Download the PDF for Arduino:
https://drive.google.com/open?id=1n231PI2jg8BQcIFIccbpYRfGLHEpQoP0

Download the Mixly Code and PDF:
https://drive.google.com/open?id=1FJTT0eiIYVB6ZHNKM657LFCRkHGAJ5yk


Buy from