Ks0113 keyestudio EASY plug Capacitive Touch Sensor

From Keyestudio Wiki
Revision as of 16:13, 7 January 2021 by Keyestudio (talk | contribs) (→‎Resources)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
EASY plug Capacitive Touch Sensor

Introduction

You can find touch sensors mostly on electronic device. Instead of buttons, upgrade your Arduino project with our new version touch sensor and make it cool!
The EASY Plug digital capacitive touch sensor provides a one-touch style switch on your Arduino project. It uses the most popular capacitive sensing technology which is the same as your mobile phone.
This little sensor can "feel" people and metal touch and feedback a high/low voltage level. Even isolated by some cloth and paper, it can still feel the touch. The sensitivity will decrease as the isolation getting thick.
This module should be used together with EASY plug control board.

Special Note:
The sensor/module is equipped with the RJ11 6P6C interface, compatible with our keyestudio EASY plug Control Board with RJ11 6P6C interface.
If you have the control board of other brands, it is also equipped with the RJ11 6P6C interface but has different internal line sequence, can’t be used compatibly with our sensor/module.



Features

  • Connector: Easy plug
  • Supply Voltage: 3.3V to 5V
  • Sensor type: Digital
  • Function range: 0℃ to 100℃


Technical Details

  • Dimensions: 45mm*20mm*18mm
  • Weight: 4.9g


Connect It Up

Connect the EASY Plug touch sensor and LED module to control board using RJ11 cable. Then connect the control board to your PC with a USB cable.
thumb


Upload the Code


Below is an example code. Open or drag below code to Mixly Blocks and upload.

thumb


What You Should See

Done uploading the code, when you touch the sensor, the led on the sensor will light up.
thumb

Open the monitor, it will print out the value read from the touch sensor.
thumb


Simulating Table Lamp


Test Code
thumb

What You Should See
Powered up and upload well the code, press down the button, LED light is turned on, it will not be off when release the button; But if press the button once again, LED will be turned off. It seems like your table lamp.

thumb

Open the monitor, you should be able to see how many times do you touch the sensor.
thumb


Troubleshooting:

  • Program Not Uploading?

This happens sometimes, the most likely case is a confused Board and serial port, you should firstly select your proper board and port.
If it doesn’t, make sure you have assembled the circuit correctly and verified and uploaded the code to your board.

thumb



Resources

https://fs.keyestudio.com/KS0113


Buy from