Ks0115 keyestudio EASY plug Digital Tilt Sensor Module: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
Line 52: Line 52:
http://www.keyestudio.com/keyestudio-easy-plug-digital-tilt-sensor-module-for-arduino-starter.html
http://www.keyestudio.com/keyestudio-easy-plug-digital-tilt-sensor-module-for-arduino-starter.html


[[category:Module]]
[[category:EASY Plug]]

Revision as of 10:45, 30 October 2018

EASY plug Digital Tilt Sensor Module


thumb

Introduction

Tilt Sensor is a digital tilt switch. It can be used as a simple tilt sensor. Simply plug it to our IO/Sensor shield; you can make amazing interactive projects. With dedicated sensor shield and Arduino, you can achieve interesting and interactive work.
Note: this module needs to be used together with EASY plug control board.


Specification

  • Interface: Easy plug
  • Supply Voltage: 3.3V to 5V
  • Sensor type: Digital
  • Size: 39*20mm
  • Weight: 5g

Connection Diagram


thumb


Sample Code

int ledPin = 13;                // Connect LED to pin 13
int switcher = 10;                 // Connect Tilt sensor to Pin10
void setup()
{
 pinMode(ledPin, OUTPUT);      // Set digital pin 13 to output mode
 pinMode(switcher, INPUT);       // Set digital pin 10 to input mode
}
void loop()
{
   
  if(digitalRead(switcher)==HIGH) //Read sensor value
    {
       digitalWrite(ledPin, HIGH);   // Turn on LED when the sensor is tilted
    }
  else
    {
       digitalWrite(ledPin, LOW);    // Turn off LED when the sensor is not triggered
    }
}

Resources

PDF

https://drive.google.com/open?id=11zcE-Avm45q59CnFpU486L5WpoqgaPB9

Buy from

Official Website

http://www.keyestudio.com/keyestudio-easy-plug-digital-tilt-sensor-module-for-arduino-starter.html