Ks0117 keyestudio EASY plug Vibration Sensor Module

EASY plug Vibration Sensor Module

Introduction

What's the simplest way to check vibration with Arduino? Well, use a vibration sensor from keyestudio. You can directly plug it on our sensor Shield V5, vibrate this sensor, and Arduino can receive a digital signal, making it easy to make computation and programs in Arduino.
Despite its simplicity, you can make full use of it with creative thinking, step counting, and crash warning light etc.
Note: this module needs to be used together with EASY plug control board.

Specification

• Interface: Easy plug
• Sensor type: Digital
• Supply Voltage: 3.3V to 5V
• Size: 46.4*16.6mm
• Weight: 7g

Connection Diagram

Sample Code

#define SensorLED     13
#define SensorINPUT   7  //Connect the sensor to digital Pin 7 which is Interrupt 1.
unsigned char state = 0;
void setup()
{
 pinMode(SensorLED, OUTPUT);
 pinMode(SensorINPUT, INPUT);
 attachInterrupt(1, blink, FALLING);// Trigger the blink function when the falling edge is detected
 }
void loop()
{  if(state!=0)
     {
       state = 0;
       digitalWrite(SensorLED,HIGH);
       delay(500);
     }  
     else
       digitalWrite(SensorLED,LOW);
}
void blink()//Interrupts function
{  state++;
}

Resources

PDF

https://drive.google.com/open?id=1ggDlubS52kEVdIDCA5jAXhc0yks437FK

Buy from

Official Website

http://www.keyestudio.com/keyestudio-easy-plug-vibration-sensor-module-for-arduino.html