Ks0127 keyestudio EASY plug Single Relay Module

EASY plug Single Relay Module

Introduction

Relay is an automatic switch element with isolation function. It's widely used in remote control, remote sensing, communication, automatic control, mechatronics and electronic devices. It is one of the most important control elements. Besides, it’s easy to control and use just by inputting different level signals to corresponding ports of the relay. The single relay we introduced here has a status indicator light, convenient for you to observe the on and off status of the relay.
Note: this module needs to be used together with EASY plug control board.

Specification

• Interface: Easy plug
• Type: Digital
• Rated current: 10A (NO) 5A (NC)
• Maximum switching voltage: 150VAC 24VDC
• Digital interface
• Control signal: TTL level
• Rated load: 8A 150VAC (NO) 10A 24VDC (NO), 5A 250VAC (NO/NC) 5A 24VDC (NO/NC)
• Maximum switching power: AC1200VA DC240W (NO) AC625VA DC120W (NC)
• Contact action time: 10ms
• Size: 46.5*28mm
• Weight: 17g

Connection Diagram

Now, let’s connect this module to the D8 port of the controller board using the EASY plug cable.

Sample Code

 int Relay = 8;
  void setup()
{
  pinMode(Relay, OUTPUT);     //Set Pin3 as output
}
void loop()
{
  digitalWrite(Relay, HIGH);   //Turn on relay
  delay(1000);
  digitalWrite(Relay, LOW);   //Turn on relay
  delay(1000);                
}

Resources

PDF

https://drive.google.com/open?id=10Rqkgo0IfpkSBjd4xDaCyRG-npQiFv4v

Buy from

Official Website

http://www.keyestudio.com/keyestudio-easy-plug-single-relay-module-for-arduino.html