Ks0263 keyestudio Single Solid State Relay Module: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
No edit summary
Line 79: Line 79:


*[https://www.aliexpress.com/store/product/Free-shiping-Single-One-Channel-Solid-State-Relay-Module-red-FOR-arduino/1452162_32317853280.html?spm=2114.12010615.8148356.5.592b40a3PwpKEs    '''Shop on aliexpress''' ]
*[https://www.aliexpress.com/store/product/Free-shiping-Single-One-Channel-Solid-State-Relay-Module-red-FOR-arduino/1452162_32317853280.html?spm=2114.12010615.8148356.5.592b40a3PwpKEs    '''Shop on aliexpress''' ]
*[https://www.amazon.com/dp/B07DRHBKFV  '''Shop on amazon''' ]




[[Category:Module]]
[[Category:Module]]

Revision as of 16:01, 5 November 2019



Introduction

Keyestudio single solid state relay is active at LOW level, that is to say, the input control signal is the low level (0-1.5 V), the relay is on; while the input control signal is high level (3-5 V), the relay is off.

Solid State Relay is a new kind of contactless switching device, which is composed of all solid state electronic components.

Compared with the electromagnetic relay, it has higher reliability, with the features of non-contact, long service life, fast speed and less outside interference.
The output control terminal of keyestudio solid-state relay must be connected to the circuit, can only be AC (Alternating Current) , so that the solid state relay can be disconnected normally.


thumb


Performance Parameters

  • Electrical parameters:
Voltage Static Current Working Current Trigger Voltage Trigger Current
DC 5V 0mA 12.5mA 0-1.5V 2mA


  • Output port: AC240V/2A


thumb


Connection Diagram


thumb


Sample Code

 int Relay = 3;
  void setup()
{
  pinMode(Relay, OUTPUT);     //Set Pin3 as output
}
void loop()
{
          digitalWrite(Relay, HIGH);   //Turn off relay
          delay(1000);
          digitalWrite(Relay, LOW);    //Turn on relay
          delay(1000);
}


Result

Wiring as the above image, after powered-on, the solid state relay breaks for 1S and then connects for 1S, repeating alternately.


Resource

  • PDF:

https://drive.google.com/open?id=1C0f5uDnMY0N0e-UlOd_acrUE6oyRlj6P

  • Code:

https://drive.google.com/open?id=1L_WlBpn67Kd0U19TwvQYFyEm3chsK3iT

  • VIDEO:

http://video.keyestudio.com/ks0263/



Buy from