Ks0265 keyestudio Four-channel Solid State Relay Module

From Keyestudio Wiki
Revision as of 14:16, 31 July 2017 by Keyestudio (talk | contribs) (Created page with "==Keyestudio Four-channel Solid State Relay Module== thumb ==Introduction== Keyestudio two-channel solid state relay is a low level and effective so...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Keyestudio Four-channel Solid State Relay Module

KS0265 (1).jpg

Introduction

Keyestudio two-channel solid state relay is a low level and effective solid state relay, that is to say, the input control signals is the low level (0-1.5 V), the relay is on; while the input control signal is high level (3-5 V), the relay is off. Solid State Relay is a new kind of contactless switching device which is composed of all solid state electronic components. Compared with the electromagnetic relay, its reliability is more higher, with the features of non-contact, long service life, fast and less outside interference. The output control terminal of the keyestudio solid-state relay must be connected to the circuit, and its working current needs to be bigger than 50mA, so that the solid state relay can be disconnected normally.

Performance Parameters

  • Electrical parameters:
Voltage Static Current Working Current Trigger Voltage Trigger Current
Channel 1 DC 5V 0mA 12.5mA 3.3-5V 2mA
Channel 2 DC 5V 0mA 12.5mA 3.3-5V 2mA
Channel 3 DC 5V 0mA 12.5mA 3.3-5V 2mA
Channel 4 DC 5V 0mA 12.5mA 3.3-5V 2mA
  • Output port : AC240V/2A

Connection Diagram


thumb

Sample Code

int BASE = 3 ;  //The first relay I/O port
int NUM = 4;   //Total number of relay
void setup()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     pinMode(i, OUTPUT);   //Set the digital I/O port to output
   }
}

void loop()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, HIGH);    //Set the digital I/O port outputs to "HIGH", that is, gradually open
     delay(200);        //delay
   }
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, LOW);    //Set the digital I/O port outputs to "LOW", that is, gradually close relay
     delay(200);        //delay
   }  
}

Result

Wiring as the above image, after power-on, the four-channel solid state relays are first connected and then broken successively, which is cycling alternately.

Resource

Datasheet http://www.keyestudio.com/files/index/download/id/1500516950/

Buy from

http://www.keyestudio.com/keyestudio-four-channel-solid-state-relay.html