Ks0266 keyestudio Eight-channel Solid State Relay Module

Keyestudio Eight-channel Solid State Relay Module

Introduction

Keyestudio eight-channel solid state relay is a high level and effective solid state relay, that is to say, the input control signals is the high level (3.3-5 V), the relay is on; while the input control signal is high level (0-2.5 V), the relay is off. Solid State Relay is a new kind of contactless switching device which is composed of all solid state electronic components. Compared with the electromagnetic relay, its reliability is more higher, with the features of non-contact, long service life, fast and less outside interference. The output control terminal of the keyestudio solid-state relay must be connected to the circuit, and its working current needs to be bigger than 50mA, so that the solid state relay can be disconnected normally.

Performance Parameters

• Electrical parameters:

	Voltage	Static Current	Working Current	Trigger Voltage	Trigger Current
Channel 1	DC 5V	0mA	13.8mA	3.3-5V	2mA
Channel 2	DC 5V	0mA	26.8mA	3.3-5V	2mA
Channel 3	DC 5V	0mA	37mA	3.3-5V	2mA
Channel 4	DC 5V	0mA	48mA	3.3-5V	2mA
Channel 5	DC 5V	0mA	59mA	3.3-5V	2mA
Channel 6	DC 5V	0mA	70mA	3.3-5V	2mA
Channel 6	DC 5V	0mA	81mA	3.3-5V	2mA
Channel 6	DC 5V	0mA	90mA	3.3-5V	2mA

• Output port ： AC240V/2A

Connection Diagram

Sample Code

int BASE = 3 ;  //The first relay I/O port
int NUM = 8   //Total number of relay
void setup()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     pinMode(i, OUTPUT);   //Set the digital I/O port to output
   }
}

void loop()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, HIGH);    //Set the digital I/O port outputs to "HIGH", that is, gradually open relay
     delay(200);        //delay
   }
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, LOW);    //Set the digital I/O port outputs to "LOW", that is, gradually close relay
     delay(200);        //delay
   }  
}

Result

Wiring as the above image, after power-on, the eight-channel solid state relays are first connected and then broken successively, which is cycling alternately.

Resource

Datasheet http://www.keyestudio.com/files/index/download/id/1500517396/

Buy from

http://www.keyestudio.com/keyestudio-eight-channel-solid-state-relay.html