Ks0266 keyestudio Eight-channel Solid State Relay Module

From Keyestudio Wiki
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.


Keyestudio Eight-channel Solid State Relay Module


thumb


Introduction

Keyestudio eight-channel solid state relay is active at HIGH level, that is to say, the input control signal is the high level (3.3-5 V), the relay is on; while the input control signal is low level (0-2.5 V), the relay is off.

Solid State Relay is a new kind of contactless switching device, which is composed of all solid state electronic components.

Compared with the electromagnetic relay, it has higher reliability, with the features of non-contact, long service life, fast speed and less outside interference.
The output control terminal of keyestudio solid-state relay must be connected to the circuit, can only be AC (Alternating Current) , so that the solid state relay can be disconnected normally.


thumb


Performance Parameters

  • Electrical parameters:
Voltage Static Current Working Current Trigger Voltage Trigger Current
Channel 1 DC 5V 0mA 13.8mA 3.3-5V 2mA
Channel 2 DC 5V 0mA 26.8mA 3.3-5V 2mA
Channel 3 DC 5V 0mA 37mA 3.3-5V 2mA
Channel 4 DC 5V 0mA 48mA 3.3-5V 2mA
Channel 5 DC 5V 0mA 59mA 3.3-5V 2mA
Channel 6 DC 5V 0mA 70mA 3.3-5V 2mA
Channel 7 DC 5V 0mA 81mA 3.3-5V 2mA
Channel 8 DC 5V 0mA 90mA 3.3-5V 2mA
  • Output port: AC 100V/2A


Connection Diagram


thumb


Sample Code

int BASE = 3 ;  //The first relay I/O port
int NUM = 8 ;  //Total number of relay
void setup()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     pinMode(i, OUTPUT);   //Set the digital I/O port to output
   }
}

void loop()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, HIGH);    //Set the digital I/O port outputs to "HIGH", that is, gradually open relay
     delay(200);        //delay
   }
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, LOW);    //Set the digital I/O port outputs to "LOW", that is, gradually close relay
     delay(200);        //delay
   }  
}


Result

Wiring as the above image, after powered-on, eight-channel solid state relays are first connected and then broken successively,repeating alternately.


Resource

  • Code:

https://fs.keyestudio.com/KS0266



Buy from