Ks0278 keyestudio BH1750FVI Digital Light Intensity Module

From Keyestudio Wiki
Jump to navigation Jump to search

Keyestudio BH1750FVI Digital Light Intensity Module


thumb

Introduction

Keyestudio BH1750FVI digital light intensity module is a digital light intensity sensor integrated circuit used for two-wire serial bus interface. It uses the light intensity data collected by module to adjust the brightness of LCD and keyboard backlight. The module resolution can detect a wide range of light intensity changes.

Specification

  • Diameter 26mm, large diameter 28.5mm, high 26mm (plus light ball)
  • Working voltage: DC 5V
  • Communication interface: IIC
  • Input light range: 1-65535lx
  • Spectral sensitivity: typical value of peak sensitivity wavelength: 560nm
  • Weak dependency on light source: incandescent, fluorescent, halogen, white LED and fluorescent is available.

Connection Diagram


thumb

Sample Code

Get Library of Wire: [1]

  /*
 Measurement of illuminance using the BH1750FVI sensor module
 Connection:
  Module      UNO
G <----->   GND
V  <----->  5V
SDA  <----->  A4
  SCL  <----->  A5
   */
#include <Wire.h>

#define ADDRESS_BH1750FVI 0x23    //ADDR="L" for this module
#define ONE_TIME_H_RESOLUTION_MODE 0x20
//One Time H-Resolution Mode:
//Resolution = 1 lux
//Measurement time (max.) = 180ms
//Power down after each measurement
 byte highByte = 0;
 byte lowByte = 0;
 unsigned int sensorOut = 0;
 unsigned int illuminance = 0;

 void setup()
 {
     Wire.begin();
     Serial.begin(115200);
 }

 void loop()
 {
     Wire.beginTransmission(ADDRESS_BH1750FVI); //"notify" the matching device
     Wire.write(ONE_TIME_H_RESOLUTION_MODE);     //set operation mode
     Wire.endTransmission();

     delay(180);

     Wire.requestFrom(ADDRESS_BH1750FVI, 2); //ask Arduino to read back 2 bytes from the sensor
     highByte = Wire.read();  // get the high byte
     lowByte = Wire.read(); // get the low byte

     sensorOut = (highByte<<8)|lowByte;
     illuminance = sensorOut/1.2;
     Serial.print(illuminance);    Serial.println(" lux");

     delay(1000);
 }

Test Result

For the light intensity, the value will make a corresponding change. The light is strong, the value is large; otherwise, the value is small. Open the serial monitor and set the baud rate of 115200, as the figure shown below:


thumb

Resource

Datasheet:
https://drive.google.com/open?id=1sJup2MWqVL8z_oTPvGZDG77a_qI22d5h

Get Library of Wire:
https://drive.google.com/open?id=1ps08N3Oc12y5St3HODk81w3NmUuBGL5-

VIDEO:
http://www.keyestudio.com/wp/ks0278/

Buy from

http://www.keyestudio.com/keyestudio-breadboard-power-supply-module-black-environmental-friendly.html