Ks0366 Keyestudio ESP13 Shield Serial Port Module

Keyestudio MEGA Protoshield V3

Introduction

Nowadays, WiFi is seen everywhere in our daily life and Arduino microcontrollers are getting more and more popular.
The keyestudio ESP13 shield is particularly designed for Arduino microcontrollers to connect the WiFi.
It adopts industrial grade chip ESP8266. It is ESP-13 with metal shield, with strong anti-interference ability.
The pin is compatible with the main control board such as Arduino Uno and Mega2560. Meanwhile, it uses the voltage conversion chip when connecting the Arduino MCU, which compatibles with 3.3V and 5V.
The serial port of the shield is controlled by a dual-dial switch, so that it can be used alone as an Arduino MCU expansion board or as an ESP8266 shield.
It configures WiFi and serial parameters based on Web Server.
It can not only be used as an independent ESP8266 development board, downloading official AT command firmware, NodeMCU open source firmware and so on, but also can be used as a stand-alone Arduino UNO shield, with all leadout pins.

Technical Details

Support wireless 802.11 b/g/n standards.
Support STA/AP working modes
Built-in TCP/IP protocol stack, able to configure a socket.
Support standard TCP/UDP Server and Client.
The serial port baud rate supporting 1200/2400/4800/9600/19200/38400/57600/74800/115200 bps.
Serial port data: 5/6/7/8 bits
Serial Parity check: None
Serial port stop bit: 1/2 bit
Standard Arduino Uno/Mega pin pitch
Breaks out Arduino Pin 2/3/4/5/6/7/8/9/10/11/12/13
ESP8266 GPIO 0/2/4/5/9/10/12/13/14/15/16/ADC/EN/UART/ TX/UART RX/UART
RESET button
KEY button for multiplexing configuration function
Two DIP switches enable extended switching between the Arduino and ESP8266 serial ports.
WiFi operating current: continuous transmission≈700mA(200mA MAX), standby <200uA.
Wireless transmission rate: 110-460800bps
Working temperature: -40℃ ~ +125℃
Dimensions: 69mm*54mm*19mm
Weight: 22.7g

Pins:

Controllers Compatible

keyestudio MEGA 2560 R3
Arduino MEGA 2560 R3

Technical Details

Dimensions: 106mm x 56mm x 19mm
Weight (only MEGA protoshield): 27.2g

Back View:

Pinout Instructions

Tiny Breadboard

This is a solderless tiny breadboard. It has 10 columns, and 17 rows - a total of 170 tie in points. This tiny breadboard has a self-adhesive on the back.
You can stick it on the prototyping area of protoshield for solderless operation.

Example Use

You can first stick the 170-tie points breadboard on the prototyping area of Proto Shield. Stack the shield onto UNO R3 board. Use several LEDs, resistors and breadboard jumper wires to build the circuit experiments.