Ks0109 keyestudio EASY plug Analog Rotation Sensor

From Keyestudio Wiki
Jump to navigation Jump to search
Keyestudio EASY plug Analog Rotation Sensor

Introduction

The sensor is based on a potentiometer. A potentiometer is also known as a variable resistor. It is a perfect demonstration of a variable voltage divider circuit. Its voltage can be subdivided into 1023, easy to be connected to Arduino with our sensor shield.
Combined with other sensors, you are able to make interesting projects by reading the analog value from the IO port.
This module should be used together with EASY plug control board.

Special Note:
The sensor/module is equipped with the RJ11 6P6C interface, compatible with our keyestudio EASY plug Control Board with RJ11 6P6C interface.
If you have the control board of other brands, it is also equipped with the RJ11 6P6C interface but has different internal line sequence, can’t be used compatibly with our sensor/module.


Specification

  • Connector: Easy plug
  • Supply Voltage: 3.3V to 5V
  • Sensor type: Analog


Technical Details

  • Dimensions: 39mm*20mm*29mm
  • Weight: 9.1g


Connect It Up

Connect the EASY Plug potentiometer sensor to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.
thumb


Upload the Code

Below is an example code. Open or drag below code to Mixly Blocks and upload.

thumb


What You Should See

After uploading the code, open the serial monitor and set the baud rate to 9600, you should see the analog value is showed on the monitor.

thumb

If rotate the potentiometer, the printed analog value will change within the range of 0-1023.
thumb



Extension Experiment

Controlling Light Brightness

Complete the above experiment, want to try a different experiment?
Next, you will learn how to display the potentiometer value on the 1602 LCD screen and to control the brightness of LED using a potentiometer sensor.
Let’s get started right now!


Hookup Guide
Connect the EASY Plug potentiometer sensor, a red LED module and 1602 LCD module to control board using RJ11 cables.
thumb


Test Code
Below is an example code.

thumb


What You Should See
After uploading the code, rotate the potentiometer knob, you can see the converted value by potentiometer within 0~255 on the 1602 LCD screen, controlling the brightness of LED module.
thumb


Little Knowledge:

  • Remember you can adjust the contrast by rotating a blue potentiometer on the LCD back if you can’t make out the words clearly.


thumb



Resources

https://fs.keyestudio.com/KS0109


Buy from