Ks0279 keyestudio Slide Potentiometer Module for Arduino

From Keyestudio Wiki
Jump to navigation Jump to search


Keyestudio Slide Potentiometer Module for Arduino


thumb


Introduction

Keyestudio slide potentiometer module using high-quality sliding electrical appliance, has the performances of stability and reliability.
It is a dual analog output, and outputs 0-VCC analog voltage signal.

thumb


Specification

  • Voltage：3.3V、5V
  • Port：analog quantity
  • Resistance value：5K
  • Platform：Arduino、microcontrollers、ARM and other microcontrollers platform
  • Dimensions：90mm*27mm*30mm
  • Weight：14.7g


thumb


Connection Diagram


thumb


Sample Code

void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
}

// the loop routine runs over and over again forever:
void loop() {
  // read the input on analog pin 0:
  int sensorValue = analogRead(A0);
  // print out the value you read:
  Serial.println(sensorValue);
  delay(1);        // delay in between reads for stability
}


Test Result

After connecting and burning the program, powered-on, open the serial monitor, and you can see the analog value of analog port A0, as the figure shown below.
When sliding the slide pole, the value ranges from 0 to 1023.

thumb


Application


thumb


Resource

  • Source Code:

https://fs.keyestudio.com/KS0279

  • VIDEO:

http://video.keyestudio.com/ks0279/


Get One Now

Retrieved from "http://wiki.keyestudio.com/index.php?title=Ks0279_keyestudio_Slide_Potentiometer_Module_for_Arduino&oldid=30780"