View source for Ks0279 keyestudio Slide Potentiometer Module for Arduino

==Keyestudio Slide Potentiometer Module for Arduino==
<br>[[File:Ks0279 滑调电位器.png|500px|frameless|thumb]]<br>

==Introduction ==
Keyestudio slide potentiometer module using high-quality sliding electrical appliance, has the performances of stability and reliability. It is a dual analog output, and outputs 0-VCC analog voltage signal.

<br>[[File:KS0279-2.png|500px|frameless|thumb]]<br>


==Specification==
* Size：27*90*30mm
* Weight：14.7g
* Voltage：3.3V、5V
* Port：analog quantity
* Numerical value of resistance：10K
* Platform：Arduino、microcontrollers、ARM and other microcontrollers'platform.

<br>[[File:KS0279-6.png|500px|frameless|thumb]]<br>

==Connection Diagram ==

<br>[[File:Ks0279.png|500px|frameless|thumb]]<br>

==Sample Code ==
<pre>
void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
}

// the loop routine runs over and over again forever:
void loop() {
  // read the input on analog pin 0:
  int sensorValue = analogRead(A0);
  // print out the value you read:
  Serial.println(sensorValue);
  delay(1);        // delay in between reads for stability
}
</pre>

==Test Result ==
Connecting the wire and burning the program, after powered-on, please open the serial monitor, and you can see the analog value of analog port A0, as the figure shown below. When sliding the slide pole, the value ranges from 0 to 1023.

<br>[[File:Ks0279-.png|500px|frameless|thumb]]<br>

== Applications ==
<br>[[File:KS0279 (8).jpg|500px|frameless|thumb]]<br>

==Resource ==
'''PDF File:''' <br>
https://drive.google.com/open?id=1lPlAY3qC57W6g-BVaTOS7uql7x34hsAi

'''VIDEO:''' <br>
http://www.keyestudio.com/wp/ks0279/

==Get One Now ==
http://www.keyestudio.com/ks0279.html


[[Category: Module ]]