Ks0126 keyestudio EASY plug IR Transmitter Module

EASY plug IR transmitter Module

Introduction

An infrared transmitter is simply a Light Emitting Diode which generates IR light (invisible IR light).
In an infrared remote control, for example, pushing a button sends an electric signal to the LED, which converts the signal into a beam of infrared light. The receiving device detects the light with a photo diode and converts it to an electrical signal via an integrated circuit, thus control its actions.
Infrared transmitters are widely used as a means of wireless communication by remote controls for televisions and other electronic devices. This IR transmitter module is designed for IR communication when paired with IR receiver module.  Note: this module should be used together with EASY plug control board.

Specification

• Power Supply: 3-5V
• Infrared light wavelength: 940mm
• Infrared emitting angle: about 20 degrees
• Infrared emitting distance: about 1.3m
• Modulate Frequency: 38Khz
• Comes with a mounting hole
• High quality connector

Technical Details

• Dimensions: 44mm*20mm*18mm
• Weight: 4.5g

Connect It Up

Connect the EASY Plug Infrared transmitter sensor to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.

Upload the Code

Copy and paste below code to Arduino IDE and upload.

#include <IRremote.h>
IRsend irsend;
void setup()
{
Serial.begin(9600);
}
void loop() {
irsend.sendSony(0xa90, 12); // Sony TV power code
delay(100);
}

Resources

Download the PDF:
https://drive.google.com/open?id=1UkrRZFxKu2A4CUS_Ug_-hyh4U4c77B2m

Download the libraries:
https://drive.google.com/open?id=1CEZEdIN_apPnQ69adX4lVsyWosXM0GGa

Download the code:
https://drive.google.com/open?id=1krXFwgIZFS39wrOVsAhtclTeHnsjLLoa

Buy from

• Official Website: http://www.keyestudio.com/ks0126.html