Ks0052 keyestudio PIR Motion Sensor: Difference between revisions
Keyestudio (talk | contribs) |
Keyestudio (talk | contribs) |
||
| Line 18: | Line 18: | ||
== Parameters== | == Parameters== | ||
* Input Voltage: 3. | * Input Voltage: DC 3.3V~18V | ||
* Working Current: 15uA | * Working Current: 15uA | ||
* Working Temperature: -20 ~ 85 ℃ | * Working Temperature: -20 ~ 85 ℃ | ||
| Line 27: | Line 27: | ||
* Output Indicator LED (If it is HIGH level, it will be ON) | * Output Indicator LED (If it is HIGH level, it will be ON) | ||
* Pin Limit Current: 100mA | * Pin Limit Current: 100mA | ||
==Pinout== | ==Pinout== | ||
Revision as of 14:58, 11 January 2019
Introduction
The Pyroelectric infrared motion sensor can detect infrared signals from a moving person or moving animal, and output switching signals. It can be applied to a variety of occasions to detect the movement of human body. Conventional pyroelectric infrared sensors are much more bigger, with complex circuit and lower reliability. Now we launch this new pyroelectric infrared motion sensor, specially designed for Arduino. This sensor integrates an integrated digital pyroelectric infrared sensor, and the connection pins. It features higher reliability, lower power consumption and simpler peripheral circuit.
Features
- smaller size and light weight
- higher reliability
- lower power consumption
- simpler peripheral circuit
Parameters
- Input Voltage: DC 3.3V~18V
- Working Current: 15uA
- Working Temperature: -20 ~ 85 ℃
- Output Voltage: High 3V, Low 0V
- Output Delay Time (High Level): About 2.3 to 3 Seconds
- Detection Angle: 100°
- Detection Distance: 7 meters
- Output Indicator LED (If it is HIGH level, it will be ON)
- Pin Limit Current: 100mA
Pinout
Wire it Up
Connect the S pin of module to Digital 3 of UNO board, connect the negative pin to GND port, positive pin to 5V port.
Sample Code
Below is an example code, you can upload it to Arduino IDE.
byte sensorPin = 3;
byte indicator = 13;
void setup()
{
pinMode(sensorPin,INPUT);
pinMode(indicator,OUTPUT);
Serial.begin(9600);
}
void loop()
{
byte state = digitalRead(sensorPin);
digitalWrite(indicator,state);
if(state == 1)Serial.println("Somebody is in this area!");
else if(state == 0)Serial.println("No one!");
delay(500);
}
Example Result
Done wiring and powered up, upload well the code, if the sensor detects someone moving nearby, D13 indicator on UNO board will light up, and "Somebody is in this area!" is displayed on the serial monitor.
If no movement, D13 indicator on UNO board not lights, and "No one!" is displayed on the serial monitor.
Resources
Datasheet Download:
https://drive.google.com/open?id=16aLt_zk9muADaaPwlalsnR0BnHYU4b-c
Video:
http://www.keyestudio.com/wp/ks0052/
Buy from
- Official Website: http://www.keyestudio.com/wp/ks0052/