Ks0008 keyestudio Joystick Module

Introduction

Lots of robot projects need joystick. This module provides an affordable solution. By simply connecting to two analog inputs, the robot is at your commands with X, Y control.
It also has a switch that is connected to a digital pin. This joystick module can be easily connected to Arduino by IO Shield.

Specification

• Supply Voltage: 3.3V to 5V
• Interface: Analog x2, Digital x1

Connection Diagram

Sample Code

int JoyStick_X = 0; //x
int JoyStick_Y = 1; //y
int JoyStick_Z = 3; //key
  void setup() 
{
  pinMode(JoyStick_Z, INPUT); 
  Serial.begin(9600); // 9600 bps
}
void loop() 
{
  int x,y,z;
  x=analogRead(JoyStick_X);
  y=analogRead(JoyStick_Y);
  z=digitalRead(JoyStick_Z);
  Serial.print(x ,DEC);
  Serial.print(",");
  Serial.print(y ,DEC);
  Serial.print(",");
  Serial.println(z ,DEC);
  delay(100);
}

Result

Wiring well and uploading the code, open the serial monitor and set the baud rate to 9600, push the joystick, you will see the value shown below.

Resources

Video
http://video.keyestudio.com/wp/ks0008/

PDF and Code
https://drive.google.com/open?id=1YzPn5ZazmFMd85UpyeRoGIre8DYy0QP7

Get One Now

• Get From Official Website

• From Aliexpress