Ks0186 keyestudio ACS712-20A Current Sensor

Introduction

ACS712-20A Current Sensor is used to measure the intensity of current. It contains ACS712ELC-20A chip, based on Hall Effect. You should protect it from influence of magnetic field when using it.

Parameters

• Chip:ACS712ELC-20A
• 5V Power Supply and Power Indicator On-board
• This module can detect 20A positive and negative current,corresponding analog output at 100mV/A.
• Output voltage is VCC/2 without current flowing.

Connection Diagram

Sample Code

#include <Wire.h>  //invoking I2Clibraries coming with Arduino
#include <LiquidCrystal_I2C.h>
LiquidCrystal_I2C lcd(0x27,16,2); 
int temp;
// the setup routine runs once when you press reset:
void setup() {
  // initialize serial communication at 9600 bits per second:
  lcd.init();
    delay(100);
    lcd.backlight();
    Wire.begin();  //initializing I2C
    lcd.clear(); //clear screen
    delay(100);
    lcd.setCursor(2,0);
    lcd.print("ACS712 TEST");
    delay(200);
  Serial.begin(9600);
}

// the loop routine runs over and over again forever:
void loop() {
  // read the input on analog pin 0:
  float current = analogRead(A0);
  temp=current;
  temp=temp-512;
  current=temp/19.3;
  //lcd.clear(); //clear screen
  // print out the value you read:
  Serial.print("current=");
  Serial.print(current);
  Serial.println("A");
  lcd.setCursor(0,1);
    lcd.print("Current=");
    lcd.setCursor(8,1);
    lcd.print(current);
    lcd.setCursor(15,1);
    lcd.print("A");
  delay(300);        // delay in between reads for stability
}

Download Address of Wire and LiquidCrystal_I2C Libraries：
https://drive.google.com/open?id=1JUS0I9U2N30nYCxN323SlGm9Ywm_GRp2

Result

In order to display data conveniently, add I2C LCD1602 Module. Then upload program and connect wires. After plugging in power, LED on this sensor is on and I2C LCD1602 Module displays the current intensity shown as below.

Resources

• Libraries and Code
  

https://fs.keyestudio.com/KS0186

Buy from

• Official Website

• Shop on aliexpress