Ks0265 keyestudio Four-channel Solid State Relay Module: Difference between revisions
Keyestudio (talk | contribs) |
Keyestudio (talk | contribs) |
||
Line 99: | Line 99: | ||
<br> | <br> | ||
==Resource == | ==Resource == | ||
* '''Code:''' <br> | * '''Code:''' <br> | ||
https:// | https://fs.keyestudio.com/KS0265 | ||
* '''VIDEO:''' <br> | * '''VIDEO:''' <br> | ||
Line 111: | Line 108: | ||
<br> | <br> | ||
==Buy from == | ==Buy from == | ||
Latest revision as of 10:20, 8 January 2021
Keyestudio Four-channel Solid State Relay Module
Introduction
Keyestudio four-channel solid state relay is active at HIGH level, that is to say, the input control signal is the low level (0-2.5 V), the relay is off; while the input control signal is high level (3.3-5 V), the relay is on.
Solid State Relay is a new kind of contactless switching device, which is composed of all solid state electronic components.
Compared with the electromagnetic relay, it has higher reliability, with the features of non-contact, long service life, fast speed and less outside interference.
The output control terminal of keyestudio solid-state relay must be connected to the circuit, can only be AC (Alternating Current) ,so that the solid state relay can be disconnected normally.
Performance Parameters
- Electrical parameters:
Voltage | Static Current | Working Current | Trigger Voltage | Trigger Current | |
---|---|---|---|---|---|
Channel 1 | DC 5V | 0mA | 12.5mA | 3.3-5V | 2mA |
Channel 2 | DC 5V | 0mA | 12.5mA | 3.3-5V | 2mA |
Channel 3 | DC 5V | 0mA | 12.5mA | 3.3-5V | 2mA |
Channel 4 | DC 5V | 0mA | 12.5mA | 3.3-5V | 2mA |
- Output port: AC 100V/2A
Connection Diagram
Sample Code
int BASE = 3 ; //The first relay I/O port int NUM = 4; //Total number of relay void setup() { for (int i = BASE; i < BASE + NUM; i ++) { pinMode(i, OUTPUT); //Set the digital I/O port to output } } void loop() { for (int i = BASE; i < BASE + NUM; i ++) { digitalWrite(i, HIGH); //Set the digital I/O port outputs to "HIGH", that is, gradually open delay(200); //delay } for (int i = BASE; i < BASE + NUM; i ++) { digitalWrite(i, LOW); //Set the digital I/O port outputs to "LOW", that is, gradually close relay delay(200); //delay } }
Result
Wiring as the above image,after powered-on,four-channel solid state relay is first connected and then broken successively,repeating alternately.
Resource
- Code:
https://fs.keyestudio.com/KS0265
- VIDEO:
http://video.keyestudio.com/ks0265/