Ks0279 keyestudio Slide Potentiometer Module for Arduino

Keyestudio Slide Potentiometer Module for Arduino

Introduction

Keyestudio slide potentiometer module using high-quality sliding electrical appliance, has the performances of stability and reliability.
It is a dual analog output, and outputs 0-VCC analog voltage signal.

Specification

• Voltage：3.3V、5V
• Port：analog quantity
• Resistance value：5K
• Platform：Arduino、microcontrollers、ARM and other microcontrollers platform
• Dimensions：90mm*27mm*30mm
• Weight：14.7g

Connection Diagram

Sample Code

void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
}

// the loop routine runs over and over again forever:
void loop() {
  // read the input on analog pin 0:
  int sensorValue = analogRead(A0);
  // print out the value you read:
  Serial.println(sensorValue);
  delay(1);        // delay in between reads for stability
}

Test Result

After connecting and burning the program, powered-on, open the serial monitor, and you can see the analog value of analog port A0, as the figure shown below.
When sliding the slide pole, the value ranges from 0 to 1023.

Application

Resource

• Source Code:
  

https://fs.keyestudio.com/KS0279

• VIDEO:
  

http://video.keyestudio.com/ks0279/

Get One Now

• Official website

• Shop on aliexpress