Ks0264 keyestudio Two-channel Solid State Relay Module: Difference between revisions
Keyestudio (talk | contribs) |
Keyestudio (talk | contribs) |
||
Line 78: | Line 78: | ||
'''VIDEO:''' <br> | '''VIDEO:''' <br> | ||
http://www.keyestudio.com/wp | http://www.keyestudio.com/wp/ks0264/ | ||
==Buy from == | ==Buy from == |
Revision as of 09:25, 13 April 2018
Keyestudio Two-channel Solid State Relay Module
Introduction
Keyestudio two-channel solid state relay is a low level effective solid state relay, that is to say, the input control signals is the low level (0-1.5 V), the relay is on; while the input control signal is high level (3-5 V), the relay is off. Solid State Relay is a new kind of contactless switching device which is composed of all solid state electronic components. Compared with the electromagnetic relay, its reliability is more higher, with the features of non-contact, long service life, fast and less outside interference. The output control terminal of the keyestudio solid-state relay must be connected to the circuit, and its working current needs to be bigger than 50mA, so that the solid state relay can be disconnected normally.
Performance Parameters
- Electrical parameters:
Voltage | Static Current | Working Current | Trigger Voltage | Trigger Current | |
---|---|---|---|---|---|
Channel 1 | DC 5V | 0mA | 12.5mA | 0-1.5V | 2mA |
Channel 2 | DC 5V | 0mA | 12.5mA | 0-1.5V | 2mA |
- Output port : AC240V/2A
Connection Diagram
Sample Code
int BASE = 3 ; //The first relay I/O port int NUM = 2; //Total number of relay void setup() { for (int i = BASE; i < BASE + NUM; i ++) { pinMode(i, OUTPUT); //Set the digital I/O port to output } } void loop() { for (int i = BASE; i < BASE + NUM; i ++) { digitalWrite(i, LOW); //Set the digital I/O port outputs to "low", that is, gradually open relay delay(200); //delay } for (int i = BASE; i < BASE + NUM; i ++) { digitalWrite(i, HIGH); //Set the digital I/O port outputs to "high", that is, gradually close relay delay(200); //delay } }
Result
Wiring as the above diagram, after powered-on, the two-channel solid state relay is first connected and then broken successively, repeating alternately.
Resource
PDF:
https://drive.google.com/open?id=1L_9MQoeBzdrVKn2q5G62mv0ir8x0VkjH
VIDEO:
http://www.keyestudio.com/wp/ks0264/
Buy from
Official Website
http://www.keyestudio.com/keyestudio-two-channel-solid-state-relay.html