Ks0033 keyestudio Analog Temperature Sensor

Introduction

This module is based on the working principle of a thermistor (resistance varies with temperature change in the environment).
It can sense temperature change in its surrounding and send the data to the analog IO in the Arduino board.
All we need to do is to convert the sensor output data into degrees Celsius temperature via simple programming, finally to display it.
It's both convenient and effective, thus it is widely applied in gardening, home alarm system and other devices.  

Specification

• Interface Type: analog
• Working Voltage: 5V
• Temperature Range: -55℃～315℃

Connection Diagram

Sample Code

Copy and paste the below code to Arduino software.

void setup() 
{Serial.begin(9600);
}
// the loop routine runs over and over again forever:
void loop() 
{int sensorValue = analogRead(A0);
Serial.println(sensorValue);
  delay(1); }

The above code is only for analog value.
You can see that the analog value is changing according to the temperature change in the environment. But it’s not very obvious.
Let’s solve this by using the following equation. Then upload the code below to the Arduino board. The value read from the serial port is similar to normal temperature.
e.g. The temperature right now is 30°C.

#include <math.h>
void setup()
{
   Serial.begin(9600);
}
void loop()
{
  double val=analogRead(0);
  double fenya=(val/1023)*5;
  double r=(5-fenya)/fenya*4700;
  Serial.println( 1/(  log(r/10000) /3950 + 1/(25+273.15))-273.15);
  delay(1000);
}

Result

Done wiring and powered up, upload well the code, then open the serial monitor, you will see the current temperature value. Shown below.

Extension Learn

You are able to use keyestudio analog temperature sensor to meansure the current temperature of environment, displaying the data on the LCD screen. Like below:

Resources

• Video
  

http://video.keyestudio.com/ks0033/

• PDF and Code
  

https://fs.keyestudio.com/KS0033

Buy from

• Official Website

• Shop on aliexpress