Ks0264 keyestudio Two-channel Solid State Relay Module: Difference between revisions
Keyestudio (talk | contribs) |
Keyestudio (talk | contribs) |
||
Line 84: | Line 84: | ||
<br> | <br> | ||
==Resource == | ==Resource == | ||
* '''Code:''' <br> | * '''Code:''' <br> | ||
https:// | https://fs.keyestudio.com/KS0264 | ||
* '''VIDEO:''' <br> | * '''VIDEO:''' <br> |
Latest revision as of 10:19, 8 January 2021
Keyestudio Two-channel Solid State Relay Module
Introduction
Keyestudio two-channel solid state relay is active at LOW level, that is to say, the input control signal is the low level (0-1.5 V), the relay is on; while the input control signal is high level (3-5 V), the relay is off.
Solid State Relay is a new kind of contactless switching device, which is composed of all solid state electronic components.
Compared with the electromagnetic relay, it has higher reliability, with the features of non-contact, long service life, fast speed and less outside interference.
The output control terminal of keyestudio solid-state relay must be connected to the circuit, can only be AC (Alternating Current) , so that the solid state relay can be disconnected normally.
Performance Parameters
- Electrical parameters:
Voltage | Static Current | Working Current | Trigger Voltage | Trigger Current | |
---|---|---|---|---|---|
Channel 1 | DC 5V | 0mA | 12.5mA | 0-1.5V | 2mA |
Channel 2 | DC 5V | 0mA | 12.5mA | 0-1.5V | 2mA |
- Output port: AC 100V/2A
Connection Diagram
Sample Code
int BASE = 3 ; //The first relay I/O port int NUM = 2; //Total number of relay void setup() { for (int i = BASE; i < BASE + NUM; i ++) { pinMode(i, OUTPUT); //Set the digital I/O port to output } } void loop() { for (int i = BASE; i < BASE + NUM; i ++) { digitalWrite(i, LOW); //Set the digital I/O port outputs to "low", that is, gradually open relay delay(200); //delay } for (int i = BASE; i < BASE + NUM; i ++) { digitalWrite(i, HIGH); //Set the digital I/O port outputs to "high", that is, gradually close relay delay(200); //delay } }
Result
Wiring as the above diagram, after powered-on, the two-channel solid state relay is first connected and then disconnected successively, repeating alternately.
Resource
- Code:
https://fs.keyestudio.com/KS0264
- VIDEO:
http://video.keyestudio.com/ks0264/