Ks0206 Keyestudio SR01 Ultrasonic Sensor

Introduction

The Keyestudio SR01 Ultrasonic Sensor is a very affordable proximity/distance sensor that has been used mainly for object avoidance in various robotics projects.
It essentially gives your Arduino eyes/spacial awareness and can prevent your robot from crashing or falling off a table. It has also been used in turret applications, water level sensing, and even as a parking sensor.
This simple project will use the Keyestudio SR01 Ultrasonic Sensor with an Arduino and a Processing sketch to provide a neat little interactive display on your computer screen.

Specification

• Working Voltage: DC 5V
  
• Working Current: 15mA
  
• Working Frequency: 40Hz
  
• Max Range: 5m
  
• Min Range: 2cm
  
• Measuring Angle: 15 degree
  
• Trigger Input Signal: 10µS TTL pulse
  
• Echo Output Signal Input TTL lever signal and the range in proportion
  

Connection Diagram:

SR01 Ultrasonic Sensor	UNO
VCC	5V
GND	GND
Echo	Digital Pin 7
Trig	Digital Pin 8

Sample Code

• VCC to arduino 5v
  
• GND to arduino GND
  
• Echo to Arduino pin 7
  
• Trig to Arduino pin 8
  

#define echoPin 7 // Echo Pin
#define trigPin 8 // Trigger Pin
#define LEDPin 13 // Onboard LED

int maximumRange = 200; // Maximum range needed
int minimumRange = 0; // Minimum range needed
long duration, distance; // Duration used to calculate distance

void setup() {
 Serial.begin (9600);
 pinMode(trigPin, OUTPUT);
 pinMode(echoPin, INPUT);
 pinMode(LEDPin, OUTPUT); // Use LED indicator (if required)
}

void loop() {
/* The following trigPin/echoPin cycle is used to determine the
 distance of the nearest object by bouncing soundwaves off of it. */ 
 digitalWrite(trigPin, LOW); 
 delayMicroseconds(2); 

 digitalWrite(trigPin, HIGH);
 delayMicroseconds(10); 
 digitalWrite(trigPin, LOW);

 duration = pulseIn(echoPin, HIGH);
 
 //Calculate the distance (in cm) based on the speed of sound.
 distance = duration/58.2;
 
 if (distance >= maximumRange || distance <= minimumRange){
 /* Send a negative number to computer and Turn LED ON 
 to indicate "out of range" */
 Serial.println("-1");
 digitalWrite(LEDPin, HIGH); 
 }
 else {
 /* Send the distance to the computer using Serial protocol, and
 turn LED OFF to indicate successful reading. */
 Serial.println(distance);
 digitalWrite(LEDPin, LOW); 
 }
 
 //Delay 50ms before next reading.
 delay(50);
}

Result

After upload the code to the board, open the serial monitor of Arduino IDE, you can see the distance value measured by ultrasonic sensor.

Resources

• Code
  

https://fs.keyestudio.com/KS0206

• Video:
  

http://video.keyestudio.com/ks0206/

Buy from

• Official Website

• Amazon