Ks0245 keyestudio EASY plug Joystick Module

EASY plug Joystick Module

Introduction

Lots of robot projects need joystick. This module provides an affordable solution.
By simply connecting to two analog inputs, the robot is at your commands with X, Y control. It also has a switch that is connected to a digital pin.
This joystick module can be easily connect to EASY PLUG control board with only one cable.

Specifications

• Supply Voltage: 3.3V to 5V
• Interface: Digital

Technical Details

• Dimensions: 45mm*28mm*33mm
• Weight: 12.5g

Connect It Up

Connect the EASY Plug Joystick module to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.

Upload the Code

Copy and paste below code to Arduino IDE and upload.

int JoyStick_X = 6; //x
int JoyStick_Y = 7; //y
int JoyStick_Z = 2; //key
  void setup() 
{
  pinMode(JoyStick_Z, INPUT); 
  Serial.begin(9600); // 9600 bps
}
void loop() 
{
  int x,y,z;
  x=analogRead(JoyStick_X);
  y=analogRead(JoyStick_Y);
  z=digitalRead(JoyStick_Z);
  Serial.print(x ,DEC);
  Serial.print(",");
  Serial.print(y ,DEC);
  Serial.print(",");
  Serial.println(z ,DEC);
  delay(100);
}

What You Should See

Done uploading the code, open the serial monitor and set the baud rate to 9600. If push the Joystick button towards different direction, you should get the different value.

Resources

Download the PDF:
https://drive.google.com/open?id=1eN8fs6Ew9sOMBcJxqhNgWk3qrMnSba9S

Download the Code:
https://drive.google.com/open?id=1QTwt5lOX7qMmIkL-I0b9ANV1N-6RLYl6

Buy from

Official Website
http://www.keyestudio.com/easy-plug-joystick-module.html