Ks0041 keyestudio Analog Alcohol Sensor: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
No edit summary
Line 39: Line 39:
<br>
<br>
== Result ==
== Result ==
<br>[[File:KS0349 26-2.png|500px|frameless|thumb]]<br>
<br>[[File:KS0349 26-2.png|600px|frameless|thumb]]<br>
Done wiring and powered up, upload well the code, then open the serial monitor and set the baud rate as 9600, you will see the analog value. When detecting the alcohol gas, the value will make a change. <br>
Done wiring and powered up, upload well the code, then open the serial monitor and set the baud rate as 9600, you will see the analog value. When detecting the alcohol gas, the value will make a change.  
<br>[[File:KS0349 26-3.png|500px|frameless|thumb]]<br>
<br>[[File:KS0349 26-3.png|600px|frameless|thumb]]<br>




<br>
<br>
==Resources ==
==Resources ==



Revision as of 11:01, 15 April 2019


Introduction

This analog gas sensor - MQ3 is suitable for detecting alcohol. It can be used in a breath analyzer.
It has good selectivity because it has higher sensitivity to alcohol and lower sensitivity to Benzine.
The sensitivity can be adjusted by rotating the potentiometer.

thumb


Specification

  • Power Supply: 5V
  • Interface Type: Analog
  • Quick response and High sensitivity
  • Simple drive circuit
  • Stable and long service life


Connection Diagram


thumb


Sample Code

///Arduino Sample Code
void setup()
{
  Serial.begin(9600); //Set serial baud rate to 9600 bps
}
void loop()
{
int val;
val=analogRead(0);//Read Gas value from analog 0
Serial.println(val,DEC);//Print the value to serial port
delay(100);
}


Result


thumb
Done wiring and powered up, upload well the code, then open the serial monitor and set the baud rate as 9600, you will see the analog value. When detecting the alcohol gas, the value will make a change.
thumb



Resources

  • Video

http://video.keyestudio.com/ks0041/

  • PDF

https://drive.google.com/open?id=1h-RmEhi0Oa3r0YZvg7Dsg1MxgrYWdTQ_



Buy from