Ks0278 keyestudio BH1750FVI Digital Light Intensity Module

Keyestudio BH1750FVI Digital Light Intensity Module

Introduction

Keyestudio BH1750FVI digital light intensity module is a digital light intensity sensor integrated circuit used for two-wire serial bus interface. It uses the light intensity data collected by module to adjust the brightness of LCD and keyboard backlight. The module resolution can detect a wide range of light intensity changes.

Specification

• Diameter 26mm, large diameter 28.5mm, high 26mm (plus light ball)
• Working voltage: DC 5V
• Communication interface: IIC
• Input light range: 1-65535lx
• Spectral sensitivity: typical value of peak sensitivity wavelength: 560nm
• Weak dependency on light source: incandescent, fluorescent, halogen, white LED and fluorescent is available.

Connection Diagram

Sample Code

Get Library of Wire： [1]

  /*
 Measurement of illuminance using the BH1750FVI sensor module
 Connection:
  Module      UNO
G <----->   GND
V  <----->  5V
SDA  <----->  A4
  SCL  <----->  A5
   */
#include <Wire.h>

#define ADDRESS_BH1750FVI 0x23    //ADDR="L" for this module
#define ONE_TIME_H_RESOLUTION_MODE 0x20
//One Time H-Resolution Mode:
//Resolution = 1 lux
//Measurement time (max.) = 180ms
//Power down after each measurement
 byte highByte = 0;
 byte lowByte = 0;
 unsigned int sensorOut = 0;
 unsigned int illuminance = 0;

 void setup()
 {
     Wire.begin();
     Serial.begin(115200);
 }

 void loop()
 {
     Wire.beginTransmission(ADDRESS_BH1750FVI); //"notify" the matching device
     Wire.write(ONE_TIME_H_RESOLUTION_MODE);     //set operation mode
     Wire.endTransmission();

     delay(180);

     Wire.requestFrom(ADDRESS_BH1750FVI, 2); //ask Arduino to read back 2 bytes from the sensor
     highByte = Wire.read();  // get the high byte
     lowByte = Wire.read(); // get the low byte

     sensorOut = (highByte<<8)|lowByte;
     illuminance = sensorOut/1.2;
     Serial.print(illuminance);    Serial.println(" lux");

     delay(1000);
 }

Test Result

For the light intensity, the value will make a corresponding change. The light is strong, the value is large; otherwise, the value is small. Open the serial monitor and set the baud rate of 115200, as the figure shown below:

Resource

Datasheet:
https://drive.google.com/open?id=1sJup2MWqVL8z_oTPvGZDG77a_qI22d5h

Get Library of Wire:
https://drive.google.com/open?id=1ps08N3Oc12y5St3HODk81w3NmUuBGL5-

VIDEO:
http://www.keyestudio.com/wp/ks0278/

Buy from

http://www.keyestudio.com/keyestudio-breadboard-power-supply-module-black-environmental-friendly.html