Ks0110 keyestudio EASY plug Hall Magnetic Sensor
Introduction
The Hall sensor is based on Hall Effect. It can detect whether there is a magnetic object nearby or not. And it correctly tells you through digital output.
This sensor uses the SFE Reed Switch - Magnetic Field Sensor. It can sense the magnetic materials within a detection range up to 75px.
The detection range and the strength of magnetic field are proportional.
It is useful for non-contact/waterproof type switches, position sensors, rotary/shaft encoders.
Note: this sensor needs to be used together with EASY plug control board.
Features
- Connector: Easy plug
- Sensing magnetic materials
- Detection range: up to 75px
- Output: Digital ON/OFF
- Detection range and magnetic field strength are proportional
Technical Details
- Dimensions: 41mm*20mm*18mm
- Weight: 4.4g
Connect It Up
Connect the EASY Plug Hall Magnetic sensor to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.
Upload the Code
Copy and paste below code to Arduino IDE and upload.
int ledPin = 13;// choose the pin for the LED
int inputPin = 9;// Connect sensor to input pin 9
int val = 0;// variable for reading the pin status
void setup() {
pinMode(ledPin, OUTPUT);// declare LED as output
pinMode(inputPin, INPUT);// declare push button as input
}
void loop(){
val = digitalRead(inputPin);// read input value
if (val == HIGH) { // check if the input is HIGH
digitalWrite(ledPin, LOW);// turn LED OFF
} else {
digitalWrite(ledPin, HIGH);// turn LED ON
}
}
What You Should See
When a magnet is approaching to the sensor, the LED will be turned on. Otherwise, the LED is off.
Resources
Download the PDF:
https://drive.google.com/open?id=100ur6ksO4Turkl6qHkmHb2atWy35kv7k
Download the Code:
https://drive.google.com/open?id=1U2Pd9XWUCM-kSSlZFRN8FwjgLWdFCx2z
Buy from
- Official Website: http://www.keyestudio.com/ks0110.html