Ks0203 keyestudio Steam Sensor
Introduction
Steam sensor is an analog sensor and can be made as a simple rainwater detector and liquid level switch. When humidity on the face of this sensor rises, output voltage will increase.
Caution: connection parts is non-waterproof, so please don’t put them into water.
Performance Parameters
1.Working Voltage: 3.3V or 5V
2.Working Current: <20mA
3.Range of Working Temperature: －10℃～＋70℃
4.Interface Type: Analog Signal Output
5.Size: 36mm x 20mm
Pin Definition:
S：Signal Output
+：Power Supply(VCC)
-：Ground(GND
Connection Diagram
Codes
void setup()
{
Serial.begin(9600); //open serial port, and set baud rate at 9600bps
}
void loop()
{
int val;
val=analogRead(0); //plug vapor sensor into analog port 0
Serial.print("Moisture is ");
Serial.println(val,DEC); //read analog value through serial port printed
delay(100);
}
Result
When you detect different degree of humidity, the sensor feedback current value. Shown as following picture, the value is displayed on serial port, when the sensor detects boiled.
Resources
Datasheet
http://www.keyestudio.com/files/index/download/id/1479182314/