Ks0036 keyestudio Flame Sensor
Revision as of 10:17, 15 April 2019 by Keyestudio (talk | contribs)
Introduction
This flame sensor can be used to detect fire or other lights with wavelength stands at 760nm ~ 1100nm.
In the fire-fighting robot game, the flame plays an important role in the probe, which can be used as the robot's eyes to find fire source.
Specification
- Supply Voltage: 3.3V to 5V
- Detection Range: 20cm (4.8V) ~ 100cm (1V)
- Rang of Spectral Bandwidth: 760nm to 1100nm
- Operating Temperature: -25℃ to 85℃
- Interface: Digital
Connection Diagram
Connect the D0 pin to digital 2, GND pin to GND port, VCC pin to 5V port.
Sample Code
const int flamePin = 2; // the number of the flame pin const int ledPin = 13; // the number of the LED pin // variables will change: int State = 0; // variable for reading status void setup() { // initialize the LED pin as an output: pinMode(ledPin, OUTPUT); // initialize the pushbutton pin as an input: pinMode(flamePin, INPUT); } void loop(){ // read the state of the value: State = digitalRead(flamePin); if (State == HIGH) { // turn LED on: digitalWrite(ledPin, HIGH); } else { // turn LED off: digitalWrite(ledPin, LOW); }
Result
Done wiring and powered up, upload well the code to the board.
Then if you put a lighter close to the sensor, when the sensor detects the flame, another led on the sensor is turned on.
Resources
- Video
http://video.keyestudio.com/ks0036/
- PDF
https://drive.google.com/open?id=1dTDZpdRHR3vbMpxszdVfiP4jjeo2Ke0m