Ks0124 keyestudio EASY plug DS18B20 Temperature Sensor

EASY plug DS18B20 Temperature Sensor

Introduction

The DS18B20 temperature sensor is exactly what it sounds like - a sensor used to measure ambient temperature.
The usable temperature ranges from -55°C to +125°C. It also supports multi-point mesh networking.

While there are many types of temperature sensors available in the market, the DS18B20 temperature sensor is the best choice in applications which require high accuracy and high reliability.
For electronic enthusiasts and hobbyists, the DS18B20 is a good start for learning and developing temperature-dependent prototypes.
Note: this module should be used together with EASY plug control board.

Specification

Connector: Easy plug
Supply Voltage: 3.3V to 5V
Temperature range: -55°C to +125°C
Interface: Digital

Technical Details

Dimensions: 38mm*20mm*18mm
Weight: 4.4g

Connect It Up

Connect the EASY Plug DS18B20 temperature sensor to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.

Upload the Code

Below is an example code. Open or drag below code to Mixly Blocks and upload.

What You Should See

Done uploading the code, open the serial monitor, on the window will print out the Celsius and Fahrenheit value.

Adding OLED Display

Hookup Guide

Test Code

What You Should See
Upload success, you should be able to see the Celsius and Fahrenheit value are printed out on the OLED screen.

Troubleshooting:

OLED Not Lighting Up?

If upload the code successfully, but LED still not lights up. Make sure your board and OLED module are connected correctly.

Upload Failed ?

This happens sometimes, the most likely case is a confused Board and serial port, you should firstly select your proper board and port.
Or check whether add the library or not.