KS0550 Keyestudio Servo Driver Expansion Board(Black and Eco-friendly)

Description

This is an Arduino servo driver shield. It has a PS2 interface for using a PS2 handle control. It contains 10 IO interfaces used to connect servos or other sensors. in addition, we have also extended RX/TX interfaces to interface with serial communication modules like BT modules. There are two LM2596 voltage regulator ICs onboard, which can provide a stable 600mA current for each servo.It is also applied to mechanical structures such as robotic arms.

Specification

• Input voltage VIN: DC 7-9V
• Input current VIN: maximum 5A
• Output voltage: 5V
• Output current: max 3A
• Voltage regulator IC: LM2596S
• Frequency: 150kHz
• PS2 interface: PS2 female 9P socket
• Working temperature: 0~50
• Size: 73*53.34mm

Wiring Diagram

Test Code

1. include <Servo.h>

Servo myservo1; Servo myservo2; Servo myservo3; Servo myservo4; int pos1 =0; void setup() {

 myservo1.attach(A1);  
 myservo2.attach(A0);
 myservo3.attach(8);
 myservo4.attach(9);
 
 myservo1.write(0);
 myservo2.write(0);
 myservo3.write(0);
 myservo4.write(0);
 delay(1000);

}

void loop() {

   for (pos1 = 0; pos1 <= 180; pos1 += 1) { // from 0 to 180
    myservo1.write(pos1);                // servo 1 rotates to pos1
    myservo2.write(pos1);                // servo 2 rotates to pos1
    myservo3.write(pos1);                // servo 3 rotates to pos1
    myservo4.write(pos1);           // servo 4 rotates to pos1
   delay(10);                          //control the speed of servos
 }
 for (pos1 = 180; pos1 >= 0; pos1 -= 1) { //from 180 to 0
    myservo1.write(pos1);           // servo 1 rotates to pos1
    myservo2.write(pos1);           // servo 2 rotates to pos1
    myservo3.write(pos1);           // servo 3 rotates to pos1
    myservo4.write(pos1);           // servo 4 rotates to pos1
   delay(10);
 }

}

Test Result

Stack the driver board onto the control board, wire up and upload the code. Four servos rotate from 0° to 180°, then from 180° to 0°.

Test Result

Stack the driver board onto the control board, wire up and upload the code. Four servos rotate from 0° to 180°, then from 180° to 0°