Ks0309 Keyestudio Thin-film Pressure Sensor (Black and Eco-friendly)
Keyestudio Thin-film Pressure Sensor
Description
This sensor adopts the new flexible nano pressure sensitive material with ultra thin film pad. It has the functions of water-proof and pressure sensitive. When the sensor detects the outside pressure, the resistance of sensor makes a change. So using the circuit, we can convert the pressure signal of sensing pressure change into the electrical signal output of corresponding change intensity. In this way, we can get the conditions of pressure changes by detecting the signal changes.
Parameters
- Working Voltage:DC 3.3V—5V
- Range:0-10KG
- Thickness:<0.25mm
- Response Point:<20g
- Repeatability:<±5.8%(50% load)
- Accuracy:±2.5%(85% range interval)
- Durability:>100 thousand times
- Initial Resistance:>100MΩ(no load)
- Response Time:<1ms
- Recovery Time:<15ms
- Working Temperature:﹣20℃—60℃
Connection Diagram
You can refer to the following connection. For UNO board and pressure sensor, connect the S pin of sensor to A0, negative pin to GND, pasitive pin to 5V.
Sample Code
Wire it up well, please upload the below code to Arduino IDE.
int s_pin = A0; void setup() { Serial.begin(9600); pinMode(s_pin,INPUT); } void loop() { Serial.println(analogRead(s_pin)); delay(500); }
Testing Result
Wiring well and uploading the code, open the serial monitor on Arduino IDE. Then, press the
sensor with your hand, the value shown on the monitor is increasing, so the sensor works
normally.
Documents
Datasheet:
https://drive.google.com/open?id=1RDzi2MQ_po1yNTrWxY2UuxJMdAdbNdYK
Get One Now
You can log onto our website to get one. Or purchase it as you like in other stores.
Official Website:
http://www.keyestudio.com/ks0309.html
AliExpress: [1]
Ebay: [2]