Ks0279 keyestudio Slide Potentiometer Module for Arduino
Keyestudio Slide Potentiometer Module for Arduino
Introduction
Keyestudio slide potentiometer module using high-quality sliding electrical appliance, has the performances of stability and reliability. It is a dual analog output, and outputs 0-VCC analog voltage signal.
Specification
- Size:27*90*30mm
- Weight:14.7g
- Voltage:3.3V、5V
- Port:analog quantity
- Numerical value of resistance:10K
- Platform:Arduino、microcontrollers、ARM and other microcontrollers'platform.
Connection Diagram
Sample Code
void setup() { // initialize serial communication at 9600 bits per second: Serial.begin(9600); } // the loop routine runs over and over again forever: void loop() { // read the input on analog pin 0: int sensorValue = analogRead(A0); // print out the value you read: Serial.println(sensorValue); delay(1); // delay in between reads for stability }
Test Result
Connecting the wire and burning the program, after powered-on, please open the serial monitor, and you can see the analog value of analog port A0, as the figure shown below. When sliding the slide pole, the value ranges from 0 to 1023.
Applications
Resource
PDF File:
https://drive.google.com/open?id=1lPlAY3qC57W6g-BVaTOS7uql7x34hsAi
VIDEO:
http://www.keyestudio.com/wp/ks0279/