Getting Started with keyestudio

From Keyestudio Wiki
Revision as of 14:03, 10 August 2016 by Keyestudio (talk | contribs)
Jump to navigation Jump to search


thumb

0. Hello World

Generally, teacher will teach us to write a simple Hello World example when start to learn a programming language. This only a basic introductory,but it is a very important process. Although you are not familiar about Arduino, do not worry. You can learn the hello world about Arduino: light up a LED. Now we take keyestudio UNO R3 Board as an example to learn how to light up a LED which is controlled by Digital 13 Pin. Before doing this, please make sure that you have downloaded the Arduino Environment and installed the keyestudio UNO R3 Driver successfully.



1. Connect keyestudio UNO R3 Board to PC

Connect the keyestudio UNO R3 Board to your computer using the USB cable. The green power LED (labeled PWR) should go on.


2. Set Editor Language of Arduino

Open Arduino IDE, click File > Preferences , find out Editor Language, choose your own language, close Arduino and open again. Here, we choose English.


File:Getting Started1.png



3. Open the Blink Example

Open the LED blink example sketch: File->Examples->01.Basics->Blink.
File:Getting Started2.png

4. Select Your Board

You'll need to select the entry in the Tools > Board menu that corresponds to your Arduino. Here we need to select Arduino Uno.
File:Getting Started3.png



5. Select Your Serial Port

Select the serial device of the Arduino board from the Tools | Serial Port menu.
File:Getting Started4.png



6. Upload the Program

Now, simply click the "Upload" button in the environment. Wait a few seconds - you should see the RX and TX leds on the board flashing. If the upload is successful, the message "Done uploading." will appear in the status bar.
File:Getting Started4.png


6. Result

A few seconds after the upload finishes, you should see the pin 13 (L) LED on the board start to blink . If it does, congratulations! You've gotten Arduino up-and-running.