KS(3001...3012)Assemble the Housing of Raspberry Pi 4: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
Line 14: Line 14:




<br>[[File:图片13001-2.png|500px|frameless|thumb]]<br> (figure 1)
<br>[[File:QQ图片202108261632.png|500px|frameless|thumb]]<br> (figure 2)
<br>[[File:图片13001-3.png|500px|frameless|thumb]]<br> (figure 3)




=== Assemble a Fan ===
=== Assemble a Fan ===
Line 25: Line 24:
Note: refer to the figure 4 and make fan’s back upward.
Note: refer to the figure 4 and make fan’s back upward.


<br>[[File:图片13001-4.png|500px|frameless|thumb]]<br>
<br>[[File:图片13001-5.png|500px|frameless|thumb]]<br> (figure 4)


== Prepare the following parts we need ==
== Prepare the following parts we need ==

Revision as of 17:02, 26 August 2021

Preparations:

What you need:



thumb

Detailed Steps

Stick Heat Sink

Take out three heat sinks and three thermal conductive adhesives.(figure 1)
Glue conductive adhesives on the heat sinks.(figure 2)
Then stick heat sinks to the Raspberry Pi 4.(figure 3)



thumb
(figure 1)
thumb
(figure 2)
thumb
(figure 3)


Assemble a Fan

Fix the fan onto the housing with screws, as shown below; Note: refer to the figure 4 and make fan’s back upward.



thumb

thumb
(figure 4)

Prepare the following parts we need


Cover the Raspberry Pi 4 with the housing And place the oval plastic board as follows; Screw them together. (figure 7)


Don’t forget to screw the bottom.(figure 8)


Paste Colloidal Particles

Then glue colloidal particles in the four grooves, as shown below;

图 图

Wire up

Respectively attach the red wire, black wire of the fan to 5V and GND of the Raspberry Pi, as shown below: Note: don’t reverse the negative and positive poles of the fan.