KS(3001...3012)Assemble the Housing of Raspberry Pi 4: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
No edit summary
 
(3 intermediate revisions by the same user not shown)
Line 4: Line 4:




<br>[[File:图片13001-1.png|500px|frameless|thumb]]<br>
 


== Detailed Steps ==
== Detailed Steps ==
Line 15: Line 14:




<br>[[File:图片13001-2.png|500px|frameless|thumb]]<br> (figure 1)
<br>[[File:QQ图片202108261632.png|500px|frameless|thumb]]<br> (figure 2)
<br>[[File:图片13001-3.png|500px|frameless|thumb]]<br> (figure 3)




=== Assemble a Fan ===
=== Assemble a Fan ===
Line 26: Line 24:
Note: refer to the figure 4 and make fan’s back upward.
Note: refer to the figure 4 and make fan’s back upward.


<br>[[File:图片13001-4.png|500px|frameless|thumb]]<br>
<br>[[File:图片13001-5.png|500px|frameless|thumb]]<br> (figure 4)


== Prepare the following parts we need ==
== Prepare the following parts we need ==


 
<br>[[File:图片13001-6.png|500px|frameless|thumb]]<br>




Line 38: Line 38:




<br>[[File:图片13001-7.png|500px|frameless|thumb]]<br>
 


Don’t forget to screw the bottom.(figure 8)
Don’t forget to screw the bottom.(figure 8)


<br>[[File:图片13001-8.png|500px|frameless|thumb]]<br>
 


== Paste Colloidal Particles ==
== Paste Colloidal Particles ==
Line 59: Line 59:




<br>[[File:图片13001-11.png|500px|frameless|thumb]]<br>

Latest revision as of 17:07, 26 August 2021

Preparations:

What you need:



thumb

Detailed Steps

Stick Heat Sink

Take out three heat sinks and three thermal conductive adhesives.(figure 1)
Glue conductive adhesives on the heat sinks.(figure 2)
Then stick heat sinks to the Raspberry Pi 4.(figure 3)



thumb
(figure 1)
thumb
(figure 2)
thumb
(figure 3)


Assemble a Fan

Fix the fan onto the housing with screws, as shown below; Note: refer to the figure 4 and make fan’s back upward.



thumb

thumb
(figure 4)

Prepare the following parts we need


thumb


Cover the Raspberry Pi 4 with the housing And place the oval plastic board as follows; Screw them together. (figure 7)



thumb


Don’t forget to screw the bottom.(figure 8)


thumb

Paste Colloidal Particles

Then glue colloidal particles in the four grooves, as shown below;

图 图

Wire up

Respectively attach the red wire, black wire of the fan to 5V and GND of the Raspberry Pi, as shown below: Note: don’t reverse the negative and positive poles of the fan.



thumb