KS(3001...3012)Assemble the Housing of Raspberry Pi 4

From Keyestudio Wiki
Revision as of 17:07, 26 August 2021 by Keyestudio (talk | contribs) (→‎Wire up)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Preparations:

What you need:



thumb

Detailed Steps

Stick Heat Sink

Take out three heat sinks and three thermal conductive adhesives.(figure 1)
Glue conductive adhesives on the heat sinks.(figure 2)
Then stick heat sinks to the Raspberry Pi 4.(figure 3)



thumb
(figure 1)
thumb
(figure 2)
thumb
(figure 3)


Assemble a Fan

Fix the fan onto the housing with screws, as shown below; Note: refer to the figure 4 and make fan’s back upward.



thumb

thumb
(figure 4)

Prepare the following parts we need


thumb


Cover the Raspberry Pi 4 with the housing And place the oval plastic board as follows; Screw them together. (figure 7)



thumb


Don’t forget to screw the bottom.(figure 8)


thumb

Paste Colloidal Particles

Then glue colloidal particles in the four grooves, as shown below;

图 图

Wire up

Respectively attach the red wire, black wire of the fan to 5V and GND of the Raspberry Pi, as shown below: Note: don’t reverse the negative and positive poles of the fan.



thumb