KS0373 EASY plug Slide Potentiometer: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
Line 33: Line 33:
==What You Should See==
==What You Should See==
<br>[[File:ks0398 11-1.png|500px|frameless|thumb]]<br>
<br>[[File:ks0398 11-1.png|500px|frameless|thumb]]<br>
After uploading the code, open the serial monitor and set the baud rate to 9600, you should be able to see the analog value of analog pin A0.  
<br>
After uploading the code, open the serial monitor and set the baud rate to 9600; <br>
you should be able to see the analog value of analog pin A0.  
If slide the slider, the value will change.  
If slide the slider, the value will change.  
<br>[[File:ks0398 11-2.png|500px|frameless|thumb]]<br>
<br>[[File:ks0398 11-2.png|500px|frameless|thumb]]<br>

Revision as of 15:10, 10 May 2019

EASY plug Slide Potentiometer

Introduction

The EASY plug slide potentiometer uses high-quality sliding appliances for stable and reliable performance. It is a dual analog output that outputs a 0-VCC analog voltage signal.
The module pins are extended into Registered jack, so you can easily connect it to EASY Plug control board using a RJ11 cable.
There are 6 pad interfaces on the module. So you can solder two 3pin headers with a pitch of 2.54mm on the module.
It can be used to connect with other MCUs. The signal terminal outputs two analog values. The sum of the two analog values is 1023.
Note: this module should be used together with EASY plug control board.


Parameters

  • Operating Voltage: DC 3.3V-5V
  • Resistance: 10K
  • Port: analog quantity
  • Property: ROHS


Technical Details

  • Dimensions: 28mm*76.7mm*31.3mm
  • Weight: 17g


Connect It Up

Connect the EASY Plug Slide Potentiometer to control board using an RJ11 cable. Then connect the control board to your PC with a USB cable.
thumb


Upload the Code


thumb


What You Should See


thumb

After uploading the code, open the serial monitor and set the baud rate to 9600;
you should be able to see the analog value of analog pin A0. If slide the slider, the value will change.
thumb


Controlling LED Brightness

Except from reading the analog value of slide potentiometer, you are able to use the slide potentiometer to control the brightness of LED.
Hookup Guide

thumb


Test Code

thumb


What You Should See
After uploading the code, slide the potentiometer, the brightness of LED will change.
thumb

Controlling Servo Angle

Hookup Guide

thumb


Test Code

thumb


What You Should See
After uploading the code, slide the potentiometer, the servo motor will rotate to a certain angle.
thumb



Resources

Download the PDF:
https://drive.google.com/open?id=1n8INX4yU_KDlEKbMbqmcpmYVBgFvHKoQ

Download the Code:
https://drive.google.com/open?id=1sGmlgFSFWkAGKCc80QdEbuzSE36RwF2m


Buy from