KS0414 Keyestudio Turbidity Sensor V1.0
Revision as of 11:23, 15 March 2019 by Keyestudio (talk | contribs) (Created page with " ==Introduction== This sensor is mainly used to test the water’s turbidity. <br> The principle is to convert the current signal into the voltage output through the circuit....")
Introduction
This sensor is mainly used to test the water’s turbidity.
The principle is to convert the current signal into the voltage output through the circuit.
Its detection range is 0%-3.5% (0-4550NTU) , with an error range of ±05%F*S.
When using, measure the voltage value of sensor’s Signal end; then work out the water’s turbidity by simple calculation formula.
Note: the sensor is not water-proof; can only place the transparent part into water.