Ks0013 keyestudio Rotary Encoder Module

From Keyestudio Wiki
Revision as of 17:15, 11 August 2016 by Keyestudio (talk | contribs) (Created page with "==Introduction== The rotary encoder can count the pulse outputting times during the process of its rotation in positive and reverse direction by rotating. This rotating coun...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Introduction

The rotary encoder can count the pulse outputting times during the process of its rotation in positive and reverse direction by rotating. This rotating counting is unlimited, not like potential counting. It can be restored to initial state to count from 0.
thumb


Specification

  • Power Supply: 5V
  • Interface: Digital
  • Size: 30*20mm
  • Weight: 7g

Connection Diagram


thumb

Sample Code

const int interruptA = 0;       
const int interruptB = 1;       
int CLK = 2;     // PIN2
int DAT = 3;     // PIN3
int BUTTON = 4;  // PIN4
int LED1 = 5;    // PIN5
int LED2 = 6;    // PIN6
int COUNT = 0;

void setup() 
 {
  attachInterrupt(interruptA, RoteStateChanged, FALLING);
 // attachInterrupt(interruptB, buttonState, FALLING);
  pinMode(CLK, INPUT); 
  digitalWrite(2, HIGH);  // Pull High Restance  
  pinMode(DAT, INPUT); 
  digitalWrite(3, HIGH);  // Pull High Restance 
 
pinMode(BUTTON, INPUT); 
  digitalWrite(4, HIGH);  // Pull High Restance
  pinMode(LED1, OUTPUT); 
  pinMode(LED2, OUTPUT); 
   Serial.begin(9600);
 }


void loop() 
{
  if  (!(digitalRead(BUTTON))) 
    {
     COUNT = 0;  
     Serial.println("STOP COUNT = 0");
     digitalWrite(LED1, LOW);
     digitalWrite(LED2, LOW);
     delay (2000);
    }
     Serial.println(COUNT);  
}

//-------------------------------------------
void RoteStateChanged() //When CLK  FALLING READ DAT
{
 if  (digitalRead(DAT)) // When DAT = HIGH IS FORWARD
   {
    COUNT++;
    digitalWrite(LED1, HIGH);
    digitalWrite(LED2, LOW);
    delay(20);
   }
 else                   // When DAT = LOW IS BackRote
   {
    COUNT--;
    digitalWrite(LED2, HIGH);
    digitalWrite(LED1, LOW);
    delay(20);
   }
}