Ks0014 keyestudio Analog Rotation Sensor

From Keyestudio Wiki
Revision as of 09:31, 27 May 2019 by Keyestudio (talk | contribs)
Jump to navigation Jump to search


KS0014 (3).jpg



Introduction

This analog Rotation Sensor is arduino compatible. It is based on a potentiometer. Its voltage can be subdivided into 1024, easy to be connected to Arduino with our sensor shield. Combined with other sensors, we can make interesting projects by reading the analog value from the IO port.


Specification

  • Supply Voltage: 3.3V to 5V
  • Interface: Analog


Connection Diagram


thumb


Sample Code

void setup()
{
  Serial.begin(9600); //Set serial baud rate to 9600 bps
}
void loop()
{
int val;
val=analogRead(0);//Read rotation sensor value from analog 0
Serial.println(val,DEC);//Print the value to serial port
delay(100);
}


Result


thumb
Done wiring and powered up, upload well the above code, then open the serial monitor and set the baud rate as 9600, finally you will see the analog value. If rotate the knob on the rotation sensor, the value will be changed within 0-1023. Shown below.
thumb


Resources

  • Video

http://video.keyestudio.com/ks0014/

  • PDF and Code

https://drive.google.com/open?id=140QRHgX-oXiunYnw3zGGlHadwrULJfLK



Get One Now