Ks0029 keyestudio Digital Push Button

From Keyestudio Wiki
Revision as of 14:51, 29 September 2016 by Keyestudio (talk | contribs)
Jump to navigation Jump to search

Introduction

This is a basic application module. You can simply plug it into an IO shield to have your first taste of Arduino.  Advantages: Wide voltage range from 3.3V to 5V Standard assembling structure (two 3mm diameter holes with multiple of 5mm as distance from center) Easily recognizable interfaces of sensors ("A" for analog and "D" for digital) Icons illustrate sensor function clearly High quality connector Immersion gold surface
thumb


Specification

  • Supply Voltage: 3.3V to 5V
  • Easy to 'plug and operate'
  • Large button keypad and high-quality first-class cap
  • Achieve interesting and interactive work
  • Interface: Digital
  • Size: 30*20mm
  • Weight: 4g

Connection Diagram


thumb

Sample Code

/* # When you push the digital button, the Led 13 on the board will turn on. Otherwise,the led turns off.
*/
int ledPin = 13;                // choose the pin for the LED
int inputPin = 3;               // Connect sensor to input pin 3 
void setup() {
  pinMode(ledPin, OUTPUT);      // declare LED as output
  pinMode(inputPin, INPUT);     // declare pushbutton as input
}
void loop(){
  int val = digitalRead(inputPin);  // read input value
  if (val == HIGH) {            // check if the input is HIGH
    digitalWrite(ledPin, LOW);  // turn LED OFF
  } else {
    digitalWrite(ledPin, HIGH); // turn LED ON
}

Video

http://www.keyestudio.com/wp/2016/05/ks0029-keyestudio-digital-push-button-module/