Ks0036 keyestudio Flame Sensor: Difference between revisions

From Keyestudio Wiki
Jump to navigation Jump to search
No edit summary
 
(One intermediate revision by the same user not shown)
Line 59: Line 59:
http://video.keyestudio.com/ks0036/
http://video.keyestudio.com/ks0036/


* '''PDF'''<br>
* '''PDF and Code'''<br>
https://drive.google.com/open?id=1dTDZpdRHR3vbMpxszdVfiP4jjeo2Ke0m
https://fs.keyestudio.com/KS0036


<br>
<br>
==Buy from ==
==Buy from ==



Latest revision as of 14:55, 7 January 2021


Introduction

This flame sensor can be used to detect fire or other lights with wavelength stands at 760nm ~ 1100nm.
In the fire-fighting robot game, the flame plays an important role in the probe, which can be used as the robot's eyes to find fire source.
thumb


Specification

  • Supply Voltage: 3.3V to 5V
  • Detection Range: 20cm (4.8V) ~ 100cm (1V)
  • Rang of Spectral Bandwidth: 760nm to 1100nm
  • Operating Temperature: -25℃ to 85℃
  • Interface: Digital


Connection Diagram

Connect the D0 pin to digital 2, GND pin to GND port, VCC pin to 5V port.
thumb


Sample Code

const int flamePin = 2;     // the number of the flame pin
const int ledPin =  13;      // the number of the LED pin
// variables will change:
int State = 0;         // variable for reading status
void setup() {
  // initialize the LED pin as an output:
  pinMode(ledPin, OUTPUT);      
  // initialize the pushbutton pin as an input:
  pinMode(flamePin, INPUT);     
}
void loop(){
  // read the state of the value:
State = digitalRead(flamePin);
  if (State == HIGH) {     
    // turn LED on:    
    digitalWrite(ledPin, HIGH);  
  } 
  else {
    // turn LED off:
    digitalWrite(ledPin, LOW); 
}


Result


thumb
Done wiring and powered up, upload well the code to the board.
Then if you put a lighter close to the sensor, when the sensor detects the flame, another led on the sensor is turned on.

thumb


Resources

  • Video

http://video.keyestudio.com/ks0036/

  • PDF and Code

https://fs.keyestudio.com/KS0036


Buy from