Ks0051 keyestudio Infrared Obstacle Avoidance Sensor

From Keyestudio Wiki
Revision as of 14:53, 15 April 2019 by Keyestudio (talk | contribs)
Jump to navigation Jump to search


Introduction

Infrared obstacle avoidance sensor is equipped with distance adjustment function and is especially designed for wheeled robots. 
This sensor has strong adaptability to ambient light and is of high precision. It has a pair of infrared transmitting and receiving tube. When infrared ray launched by the transmitting tube encounters an obstacle (its reflector), the infrared ray is reflected to the receiving tube, and the indicator will light up; the signal output interface outputs digital signal.

We can adjust the detection distance through the potentiometer knob (effective distance: 2~40cm, working Voltage: 3.3V-5V ). 
Thanks to a wide voltage range, this sensor can work steadily even under fluctuating power supply voltage and is suitable for the use of various micro-controllers,Arduino controllers and BS2 controllers. A robot mounted with the sensor can sense changes in the environment.

thumb


Specification

  • Working voltage: DC 3.3V-5V
  • Working current: ≥20mA
  • Working temperature: -10℃ to+50℃
  • Detection distance: 2-40cm
  • IO Interface: 4 PIN (-/+/S/EN)
  • Output signal: TTL voltage
  • Accommodation mode: Multi-circle resistance regulation
  • Effective Angle: 35°


Connection Diagram


thumb


Sample Code

const int sensorPin = 2;     // the number of the sensor pin
const int ledPin =  13;      // the number of the LED pin
int sensorState = 0;         // variable for reading the sensor status
void setup() {
  pinMode(ledPin, OUTPUT);      
  pinMode(sensorPin, INPUT); }
void loop(){
  // read the state of the sensor value:
  sensorState = digitalRead(sensorPin);
  // if it is, the sensorState is HIGH:
  if (sensorState == HIGH) {     
     digitalWrite(ledPin, HIGH);  
  } 
  else {
       digitalWrite(ledPin, LOW); 
  }
}


Result

Done uploading the code to board, you can see the led on both UNO board and obstacle detector sensor is turned on.
If we put a foam block in front of the sensor, this time when sensor detects the obstacle, sled on the sensor will be turned on.

thumb


Resources

  • Video

http://video.keyestudio.com/ks0051/

  • PDF

https://drive.google.com/open?id=19HbFiYtTGCL12pJj5BLl44H5_ABt_wyr



Buy from