Ks0057 keyestudio Dual Relay Module

From Keyestudio Wiki
Jump to navigation Jump to search


keyestudio Dual Relay Module


thumb


Introduction

Arduino Relay Shield employs high quality SONGLE relay with two-channel input and output. It can be connected to 250V/10A AC element or 24V/10A DC element to the maximum, therefore, it can be used to control lights, motors and etc.
It is active at LOW level. The modularized design makes it easy to connect to Arduino expansion board. The output state of the relay is shown by a LED for the convenience of actual application.


Specification

  • Control signal: TTL voltage
  • Active at LOW level
  • Rated load:
10A 250VAC 
10A 125VAC
10A 30DC
10A 28VDC
  • Rated Through-current: 10A(NO) 5A(NC)
  • Max Switching Voltage: 250VAC 30VDC
  • Contact actuation time: ﹤10ms
  • Definition of module pins:
i) Pin 1- Pin 2----Controlling end
ii) Power supply (VCC)
iii) Ground (GND)


Connection Diagram


thumb


Sample Code

int BASE = 2 ;  // I/O pin connected to the first relay
int NUM = 2;   //total number of all relays

void setup()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     pinMode(i, OUTPUT);   //set digital I/O pin as output
   }
}

void loop()
{
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, LOW);    //set digital I/O pin as ‘low’, i.e. turning off the relay gradually   
  delay(200);        //delay
   }
   for (int i = BASE; i < BASE + NUM; i ++) 
   {
     digitalWrite(i, HIGH);    // set digital I/O pin as ‘low’, i.e. turning on the relay gradually    
 delay(200);        //delay
   }  
} 


Resources

  • Video

http://video.keyestudio.com/ks0057/

Download Code: https://fs.keyestudio.com/KS0057


Buy from